Seth,
Here is what the manual says about it:
Enhanced PCI Bus Master IDE Controller with Ultra DMA 33/66/100 Support.
When I hooked up the hard drives I used the ribbon that was designated for
ATA 100 on both drives. My bios reads ATA 100 for the master and slave on
IDE 0 (both hard drives) and 66/33 for IDE 1 (the cd-rom and zip
drive). Since I flashed the bios I have not been able to duplicate the
errors I was getting, so apparently its working right. Hope this is the
info you needed. Moe
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 19:05:22 EDT