On Thu, 7 Aug 2003, Robert Eanes wrote:
> I have installed Core linux on an old PC350 with Module Support.
> Everything comes up fine except for the Nic module... 8139too.o
>
> I get unresolved symbols when trying to insmod it.
What NIC do you have? Are you sure it uses an RTL8139? I had one NIC
(whose suckiness was much higher than average) which had "8139" printed on
the main chip, but was NOT an RTL8139 (or variant).
I don't remember what type of card it was (it has since been replaced),
but I apparently had to use the "fealnx" driver with it.
> Does anyone know if module 8139too.o has dependencies that are not
> declared in the documentation?
When compiling it, run "make dep" before you compile it. That, and
loading it with "modprobe" (not "insmod") should take care of any
dependencies. Besides, once you ascertain that it works, you should never
have to load it by hand.
-- -eben ebQenW1@EtaRmpTabYayU.rIr.OcoPm home.tampabay.rr.com/hactarrm -f /bin/laden
----------------------------------------------------------------------- This list is provided as an unmoderated internet service by Networked Knowledge Systems (NKS). Views and opinions expressed in messages posted are those of the author and do not necessarily reflect the official policy or position of NKS or any of its employees.
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 16:14:53 EDT