I've had a similar issue with my laptop.. I usually take out the nic card
(assuming it is pcmcia) and place it back in.. then do the net.eth0
restart
Jason
On Mon, 8 Dec 2003, Doug Koobs wrote:
> Another small problem with the Satellite 4090XDVD. Running Slackware 9.1, and
> the 3c574_cs network module. When I close the laptop, it goes into some kind
> of power saving mode. When I bring it back up, the NIC no longer works, the
> link light is even off. Running "/etc/rc.d/rc.inet1 restart" hangs, and the
> linklight stays off. I have to reboot to get it working again. Where should I
> start on this? Googling is not turning up much...
>
> Doug
>
> -----------------------------------------------------------------------
> This list is provided as an unmoderated internet service by Networked
> Knowledge Systems (NKS). Views and opinions expressed in messages
> posted are those of the author and do not necessarily reflect the
> official policy or position of NKS or any of its employees.
>
>
-----------------------------------------------------------------------
This list is provided as an unmoderated internet service by Networked
Knowledge Systems (NKS). Views and opinions expressed in messages
posted are those of the author and do not necessarily reflect the
official policy or position of NKS or any of its employees.
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 19:28:16 EDT