On Sun, 2005-08-21 at 17:07 -0500, michael hast wrote:
> >On my system, the
> >command, sg_map and sg_scan -i show me all the usb (and other) device
> >mappings on my system.
> >
> >
> These commands give me errors. "Command not found"
Michael,
I run Sarge also. To be able to run these commands, do an
apt-get install sg3-utils
Then they will run after you load the sg module. -Eric
-----------------------------------------------------------------------
This list is provided as an unmoderated internet service by Networked
Knowledge Systems (NKS). Views and opinions expressed in messages
posted are those of the author and do not necessarily reflect the
official policy or position of NKS or any of its employees.
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 20:24:56 EDT