Well, there are some 5V potentials there which are meant for powering
devices, if for some reason a 5V and a 0V touch, it can pull quite a bit
of current, and possibly damage your board. I'd toss it.
On Sun, 2009-09-13 at 22:56 -0400, Pete Theisen wrote:
> Hi Everybody,
>
> I ran a screw through a brand new USB 2 cable, long story. Exploratory
> surgery reveals that the insulation is penetrated and maybe half of the
> shield wires are broken, but the copper wire and the aluminum wrapped
> thingie are untouched.
>
> Is it shot or not? If it was a shielded audio or TV cable I would just
> tape it up and not worry about it but I don't know a lot about USB.
-----------------------------------------------------------------------
This list is provided as an unmoderated internet service by Networked
Knowledge Systems (NKS). Views and opinions expressed in messages
posted are those of the author and do not necessarily reflect the
official policy or position of NKS or any of its employees.
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 13:30:55 EDT