Hi All:
I hope You people will have time to help a relative novice with
configuration of an HP 6100 C which is to be used intermidently on 2
different RH 7.3 systems.
As stated previously the scanner is an HP 6100C if I issue the command:
The scanner is connected by 40 pin scsi.
Several commands were issues with the following results:
$ scanimage --list devices
sg0 HP C2520A 36644
sg1 Mitsumi CD-R
sg2 Soney CD-RW
$ cat /proc/scsi/scsa
Attached devices:
Host: scsi0 Channel: 00 Id: 04 Lun: 00 Vendor: HP Model: C2520A Rev: 3644
Type: Processor ANSI SCSI revision: 02
Host: scsi1 Channel: 00 Id: 00 Lun: 00 Vendor: MITSUMI Model: CD-ROM
FX4830T!B Rev: R02C Type: CD-ROM ANSI SCSI revision: 02
Host: scsi1 Channel: 00 Id: 01 Lun: 00 Vendor: SONY Model: CD-RW CRX175E2
Rev: S002 Type: CD-ROM ANSI SCSI revision: 02
$ export SANE_DEBUGG_HP=17
$ scanimage -L
[scanei_debug] Setting debug level of hp to 17
[hp] sane_init called[hp]
[hp] sane_init will finish with Success
[hp] sane_get_devices called
[hp] hp_read_config: hp backend v0.95 start reading conf file
[hp] hp_read_config: processing line <scsi HP>
[hp] hp_read_config: processing line </dev/scaner>
[hp] hp_read_config: attach scsi HP
[hp] hp_read_config: attach /dev/scanner
[hp] hp_get_dev: New device /dev/scanner, connect-scsi, scsi-request=1
[hp] sanei_hp_device_new: /dev/scanner
[hp] scsi_newopen failed (Invalid argument)
[hp] /dev/scanner: Can't open scsi device
[hp] sane_get_devices will finish with Success
[hp] sane_exit called
[hp] sane_exit will finish
The sane configuration file /etc/sane.d/ho.conf is as follows:
scsi HP
/dev/scannet
Then I did the following:
1. Changed /dev/scanner to /dev/sg0
2. Made directory sane.d-bak
3. removed all configuration files from sane.d except hp.conf
4 as root did chmood 666 /dev/sg0
I would appreciate any advice you people may be able to offer.
Thanks
Frank
>
>
> Thanks
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 15:50:05 EDT