Thanks Smitty:
I believe that that did the trick.
The start up scrawl indicates that it is now functioning correctly - I think.
Thanks
Frank
On Monday 26 August 2002 22:31, Smitty wrote:
> Try putting the scsi card in a different slot. The irq in that slot may
> conflict with another that is established.
> Smitty
>
> On Monday 26 August 2002 18:49, you wrote:
> > Hi All
> >
> > Still mucking about part time trying to get my scanner to work again
> > after that disaster out in Arizona.
> >
> > Thank to several of you nice people's help I have it configured
> > correctly again but I am now experiencing an interrupt problem again.
> > Same as last time but unfortunately I lost the setup so I have no idea
> > do how the box was set.
> >
> > Anyway the problem seems to be interrupts 10 and 11. I say that tong in
> > cheek only because I receive an error message when the computer boots.
> >
> > At the last Tampa meeting it was suggested that this could be a product
> > of the card that I have in the box especially the network card.
> >
> > The network card has been removed since I am no longer connected to a
> > network It would be nice to have it back in the box again though so the
> > box could be connected to a DHCP cable without reconfiguring the box but
> > that is not relevant at the current moment.
> >
> > Currently the only cards in the box are: video, modem, and scsi.
> >
> > The video card fits into the funny slot with a lever which off hand I
> > can not remember the name of.
> >
> > The Modem is a UR Robotics job in a pci slot.
> >
> > The scsi card takes the scanner scsi cable connection output and sends
> > it on it merry way into the computer via a pci slot.
> >
> > Booting the computer and taking a look at the interrupts section I have
> >
> > PCI: Found IRQ 11 for device 00.0e.0
> > IRQ routing conflict 00.07.2 have IRQ 10, want IRQ 11
> > IRQ routing conflict 00.07.3 have IRQ 10, want IRQ 11
> >
> > Looking at the biso I have:
> >
> > OnChip IDE Channel 10 Enabled
> > OnChip IDE Channel 11 Enable.
> >
> > I would appreciate what advice and assistance that the group might lent.
> >
> > Thanks
> >
> > Frank
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 17:11:19 EDT