I can get my scratch pad mouse to work but can not get my USB MS
mouse to work in console (and thus Xwindows) mode. Below are the
contents from dmesg and the gpm file.
Any thoughts on what I might try?
--- dmesg ---
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.275 $ time 16:42:50 Dec 14 2002
usb-uhci.c: High bandwidth mode enabled
PCI: Found IRQ 10 for device 00:1d.0
PCI: Setting latency timer of device 00:1d.0 to 64
usb-uhci.c: USB UHCI at I/O 0x2400, IRQ 10
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
PCI: Found IRQ 11 for device 00:1d.1
PCI: Setting latency timer of device 00:1d.1 to 64
usb-uhci.c: USB UHCI at I/O 0x2420, IRQ 11
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 2
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
usb.c: registered new driver hid
hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik <vojtech@suse.cz>
hid-core.c: USB HID support drivers
mice: PS/2 mouse device common for all mice
hub.c: USB new device connect on bus1/2, assigned device number 2
hiddev0: USB HID v1.00 Mouse [Microsoft Microsoft 3-Button Mouse with
IntelliEye?] on usb1:2.0
--- gpm ----
# Additional options for gpm (e.g. acceleration), device
#
# This is the complete command we want /etc/init.d/gpm to run...
# gpm -R -m /dev/psaux -t ps2 -M -m /dev/input/mice -t imps2
#
# Here is the hack to do it...
#
# OPTIONS=""
OPTIONS="-R -m /dev/psaux -t ps2 -M"
# DEVICE="/dev/mouse"
DEVICE="/dev/input/mice"
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 20:37:36 EDT