Hi. I recently came into posession of a Dell computer case. I would use
it, except that its switches-and-LEDs connector is proprietary. It takes
pins like are on the motherboard in that area, and would fit onto them,
except (a) the pinout is wrong; (b) it's one row too short; and (c) one
hole is blocked (#14, if my count is correct).
Where could I find a block of pins (~0.1" or ~2.7mm spacing, two columns
by at least four rows) that I can solder or screw wires to, online or
brick-and-mortar? Or, can I buy somewhere an adapter, that goes to loose
connectors for power & IDE LEDs, power & reset switches?
-- -eben ebQenW1@EtaRmpTabYayU.rIr.OcoPm home.tampabay.rr.com/hactar CANCER: The position of Jupiter says that you should spend the rest of the week face down in the mud. Try not to shove a roll of duct tape up your nose when taking your driver's test. -- Weird Al----------------------------------------------------------------------- This list is provided as an unmoderated internet service by Networked Knowledge Systems (NKS). Views and opinions expressed in messages posted are those of the author and do not necessarily reflect the official policy or position of NKS or any of its employees.
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 17:27:48 EDT