Re: [SLUG] Using old ethernet wiring?

From: Paul M Foster (paulf@quillandmouse.com)
Date: Sat Jul 17 2004 - 03:31:11 EDT


On Fri, Jul 16, 2004 at 01:43:14PM -0400, Doug Koobs wrote:

<snip>

> In my electrician days, I usually used two methods, depending on the
> situation. You can use a ShopVac on one end, and a plastic baggie (called
> a "mouse") tied to a pull string on the other end. Then just suck the
> mouse and pull string through. This works best with PVC conduit, since it
> is generally more airtight than the metal varieties.
>
> You can also use a fish tape, like ths:
> http://www.divineimages.com/prod/it32/303/100/FISH/TAPE/ELECTRICIAN/PULL/WIRES.htm
>
> Just push the fish tape in one end till it pops out the other end. Not
> near as fun as the ShopVac and mouse :)
>
> Of course, you can always put a pull string in the conduit as you are
> initially installing...

Whoa. Never used a shop vac! Of course, we usually installed aluminum
flex, not PVC (this was L.A.). Usually used a fish tape on new installs.
If we had to pull more wires into an existing conduit, we'd disconnect
one of the wires and use _it_ as the "pull cord" (if a fish tape
wouldn't fit through).

Paul
-----------------------------------------------------------------------
This list is provided as an unmoderated internet service by Networked
Knowledge Systems (NKS). Views and opinions expressed in messages
posted are those of the author and do not necessarily reflect the
official policy or position of NKS or any of its employees.



This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 20:33:50 EDT