Re: [SLUG] ifconfig not gettting set

From: Mason Mullins (mason_mullins@hotmail.com)
Date: Sat May 07 2005 - 21:28:46 EDT


Is the driver being loaded before the card is coming up?

On Sat, 7 May 2005 11:28:19 -0700
Chuck Hast <wchast@gmail.com> wrote:

> Folks,
> I have asked about this before, and have poked and poked at it, what is
> at issue is that the eth0 port is not getting set up, the machine is a toshiba
> laptop, I think that the eth0 parameters are being sent to it either too soon
> (it is a pcmcia nic card) or it is getting partially setup but again possibly
> too soon.
>
> My fix has been to log in and root after the machine has finished booting
> do a ifdown eth0 and then do a ifup eth0.
>
> If I just fo a ifup eth0 it tells me that the device is already configured.
>
> When I watch the startup screen go by I see it attempt to configure eth0
> it fails and defers it then it does so again, it detects the card speed (10
> mb) but does not appear to load in the ip, mask, gw etc.
>
> I am trying to figure out where to go in and try make it do that a bit later.
> I can see possible places in the rc.d files, but even though I poke at the
> run sequences I still can not get the thing to load in the proper configur-
> ation beyond the fact that the card is there, but just needs to be pulled
> down and then up.
>
> --
> Chuck Hast
> To paraphrase my flight instructor;
> "the only dumb question is the one you DID NOT ask resulting in my going
> out and having to identify your bits and pieces in the midst of torn
> and twisted metal."
>
> -----------------------------------------------------------------------
> This list is provided as an unmoderated internet service by Networked
> Knowledge Systems (NKS). Views and opinions expressed in messages
> posted are those of the author and do not necessarily reflect the
> official policy or position of NKS or any of its employees.
-----------------------------------------------------------------------
This list is provided as an unmoderated internet service by Networked
Knowledge Systems (NKS). Views and opinions expressed in messages
posted are those of the author and do not necessarily reflect the
official policy or position of NKS or any of its employees.



This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 18:43:14 EDT