Hi Everybody,
I have three sound cards on an embedded motherboard I hope to use to
power a "Virtual Organ", the better to play organ music. In order to do
this I have to load the card's hardware synths with organ soundfonts.
That part isn't working, arghh!
# modprobe snd-emu10k1-synth
# amidi -l
Dir Device Name
IO hw:0,0 Audigy MPU-401 (UART)
IO hw:0,1 Audigy MPU-401 #2
IO hw:0,2 Emu10k1 Synth MIDI (16 subdevices)
IO hw:0,3 Emu10k1 Synth MIDI (16 subdevices)
IO hw:1,0 EMU10K1 MPU-401 (UART)
IO hw:1,1 Emu10k1 Synth MIDI (16 subdevices)
IO hw:1,2 Emu10k1 Synth MIDI (16 subdevices)
IO hw:2,0 Audigy MPU-401 (UART)
IO hw:2,1 Audigy MPU-401 #2
IO hw:2,2 Emu10k1 Synth MIDI (16 subdevices)
IO hw:2,3 Emu10k1 Synth MIDI (16 subdevices)
#
It seems to me that this output would tell me where the targets are, but
I can't seem to get the commands. It works ok on the first one, which
doesn't need a specified address, but after that it gets fussy.
asfxload American_Classic_Organ_4.0.sf2 (works, loads the first synth)
asfxload --hwdep=hw:0,3 American_Classic_Organ_4.0.sf2 (trying to load
the second synth, gives an error) "No Emux synth hwdep device is found".
Any ideas?
-- Regards,Pete http://pete-theisen.com/ http://elect-pete-theisen.com/ ----------------------------------------------------------------------- This list is provided as an unmoderated internet service by Networked Knowledge Systems (NKS). Views and opinions expressed in messages posted are those of the author and do not necessarily reflect the official policy or position of NKS or any of its employees.
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 14:04:04 EDT