Ok, here's another quandry.
Machine was normal until the power supply blows up. I replace it and boot
up. Well, not the kernel sees one Nic card and halfway sees the other.
'dmesg' shows eth0 but not eth1
/proc/pci shows both of them
/proc/interrupts shows only eth0
'ifconfig eth0' works fine
'ifconfig eth1' doesn't
BIOS wasn't changed - I have gone through it playing with the IRQ
allocation in case it was being 'difficult'
Moving the cards around in the slots disable both cards - they aren't seen
at all by the kernel.
(3Com905TX)
Anyone have a clue or do I need to continue this change-reboot cycle?
------------------------------------------------------------------------
| Mark Bishop (mark@bish.net) | Computer Engineer |
| 813.258.2390 | Network Engineer |
| http://bish.net | Embedded Programmer |
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 16:05:26 EDT