On Tue, Oct 29, 2002 at 05:42:08PM -0500, Thomas Ringate wrote:
> I am updating an older Red Hat system, Release 7.0, using RHN Update Agent
> and I need some space on the /boot partition.
>
> Presently there are four groups of files there
> module-info-2.2.xxx
> System.map-2.2.xxx
> vmlinux-2.2.xxx
> vmlinuz-2.2.xxx
>
> There is one each of these files for the following:
>
> 2.2.16-22
> 2.2.19-7.0.1
> 2.2.19-7.0.10
> 2.2.19-7.0.12
> 2.2.19-7.0.8
>
> In lilo.conf, only the
> 2.2.16-22
> 2.2.19-7.0.1
> 2.2.19-7.0.8
> are mentioned. 2.2.19-7.0.8 is what is being loaded.
>
> Not sure why I see these two:
> 2.2.19-7.0.10
> 2.2.19-7.0.12
>
> Would it be safe to delete those two groups to get the needed space for the
> new update?
> If I delete those two, is there any need to edit anything at all in
> lilo.conf since they are not mentioned?
>
> In reading the documentation on lilo.conf it says you can have up to 16
> different load modules, of course you would need disk space to hold them.
> Since I have never had a need to go back to any of the older versions,
> should I just delete them all and keep only the current version, and edit
> lilo.conf
> to reflect that, and then do the update?
>
> I have never tried to do anything like this before.
1. Back up all the stuff in this directory to somewhere safe.
2. Create a boot disk/rescue disk, if not already done.
3. Delete the version files from that directory which are not from your
running kernel. (Use uname -a to get your kernel version.)
4. Re-run lilo to ensure safe bootaciousness. ;-}
5. Reboot.
If all is okay, then you can start new tinkering in that directory. If
not, you'll need to reboot with your rescue disk in single-user mode and
copy the backed up files back to the boot directory. At that point,
you'll have to experiment a little more to find what's deletable.
Paul
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 17:06:31 EDT