I'm trying to read (and back up) a Mac-formatted (HFS+) hard drive. Anyone
done this, or have any ideas? I have it hooked to the external port on my
card, which is an Adaptec 7940UW(?), driver=aic7xxx. I have to compile in
(or modularize) support for the Mac partitioning scheme and the HFS+
filesystem; I may have already done that, and even if I haven't I should
still see the raw disk, right?
No new disks show up when I turn it on. "fdisk -l /dev/sde" returns
nothing. (New SCSI/USB disks start at sde because I already have a card
reader that takes up sda-sdd.)
I don't much care about being able to access the files here (it'd be nice
though), as long as they go back properly.
-- -eben QebWenE01R@vTerYizUonI.nOetP 1101000 1110100 1110100 1110000 0111010 0101111 0101111 1110010 1101111 1111001 1100001 1101100 1110100 1111001 0101110 1101101 1101001 1101110 1100101 0101110 1101110 1110101 0111010 0111000 0110001 0101111 ----------------------------------------------------------------------- This list is provided as an unmoderated internet service by Networked Knowledge Systems (NKS). Views and opinions expressed in messages posted are those of the author and do not necessarily reflect the official policy or position of NKS or any of its employees.
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 20:00:36 EDT